UNDER NEW OWNERSHIP.
Notice: Our bank account details have changed. See updated details at checkout. Thank you!
Notice: Our bank account details have changed. See updated details at checkout. Thank you!
$190.00 NZ
Suitable for 2 & 3 wire stators up to 20 Amps – Best!
These voltage regulators use the latest MOSFET technology for cool running reliability. Unlike the previous generation of regulators that waste power and run hot these MOSFET regulators will impress the most discerning buyer.
Generous 20 amp rating exceeds the requirements of 10 amp, 16 amp and 14.5 amp two and three wire stators commonly used on British motorcycles. Can be used on positive earth or negative earth systems.
Heavier wire connections are extra long (60 cm) in two sleeves so you can route the wires and connect them exactly as you wish.
Smaller in size makes fitting possible in tight locations under the seat or behind side panels. Cool running so you can hide it away!
Why muck around with hot unreliable regulators that waste over 20 watts of precious power when you can have the latest!
Suitable for use with 2 and 3 wire stators (single and three phase). 10 amp single phase, 16 amp single phase and 14.5 amp three phase. These stators are commonly know as RM21, RM23 and RM24 used on Triumph, Norton, BSA, Enfield, Matchless etc… compatible with any single or three phase permanent magnet 12 volt alternator up to 20 amps.
Whether you are replacing the original equipment plate rectifier and zener diode or upgrading an older reg. this one will tick all the boxes!
Comes with wiring instructions and covered by 2 year warranty.
Size is 80 x 67 x 20 mm. Mounting hole centres 64mm.
Part Number: VR-0030
WARNING: Incorrect installation will damage the regulator.
"*" indicates required fields
